Cables and Connectors

LED's and Illumination

Motors and Drivers


Esme's Electronics

Feature Teacher

Troy's Tutorials


Stepper Motor - 29 (200 steps/rev, Threaded Shaft)

4 items left

These steppers have a threaded shaft, which allows them to be used as a linear actuator. As the motor runs, it moves along the shaft at a specific rate of 1cm per 5 full rotations. These are a good choice for linear motion where precision and repeatability are important.

**Note:** It looks like the datasheet for this stepper may not be accurate. When connecting this motor to a bi-polar driver you\'ll want to wire it according to the wiring diagram in the documents below.


* Step Distance: 0.01mm
* 2-Phase
* Rated Voltage: 12V
* Rated Current: 0.4A/Phase
* 100mm Long Threaded Shaft (keyed on one end)
* Holding Torque: 21
* 6-Pin Wiring Harness Included
* NEMA 15


* [Datasheet](
* [Wiring Diagram](