Learning Developments will be on reduced hours during the school term holidays. With limited or no phone support. Orders will still be dispatched daily.



Servo:Lite Board for :MOVE Mini

1 item left

The Servo:Lite board for the BBC micro:bit is a simple board that allows you to easily connect and control low power servo motors (servo's must be capable of operating at 3.3V) using the BBC micro:bit. It is connected to the micro:bit using five bolts. Connect two servos in standard configuration and it can drive up to 3 servos if the addressable 'ZIP' LEDs aren't needed.

It is powered by 3 AAA batteries and also supplies power to the BBC micro:bit, the board features an On / off switch so when it's not in use the batteries won't drain.



The board also features 5 x RGB individually addressable ZIP LEDs (NeoPixel compatible) and additional external ZIP LEDs can be connected to the board as required.

We've produced a range of tutorials and guides that can be found in the resources section below. We have guides detailing; how to control a third servo and how to write code for the on-board ZIP LEDs.


  • Connect two servos in standard con?guration and can drive up to 3 servos if the addressable 'ZIP' LEDs aren't needed.
  • Powered by 3 AAA batteries that also supply power to the BBC microbit (not supplied).
  • On / off switch.
  • 5 x RGB addressable ZIP LEDs (NeoPixel compatible). Additional external ZIP LEDs can be connected to the board.


  • 1 x Servo:Lite board with battery holder pre-fitted.
  • 5 x M3x8 Counter sunk Pozi Steel screws.
  • 1 x Perspex spacer.


  • Length: 55mm.
  • Width: 52mm.
  • Height: 17mm.


  • 3 x AAA Batteries.
  • 1 x BBC microbit.
  • Servos.
  • Screwdriver.



  • Once the Servo:Lite board is attached to the microbit there is a maximum clearance of 6mm for the plastic sheath of the USB cable. Our noodle cables and the cable which is supplied in the official Go pack both fit.
Servo Lite USB cable

Join our VIP Club