Thanks for supporting local! Our online shop is open & shipping orders. 

Search

Cables & Connectors

Electronics Components

Motors & Controllers

On Sale items!

Get Professional Support

BBC Micro:bit

Robotics

On sale items!

Announcement


Check out our latest news to find out more about events, opportunities and partnerships.

Esmes' Electronics


Esmes' Electronics is a simple introduction to using the micro:bit written by a year 5 student.

Troys' tutorials


Learn with Troy by asking for support and, he will post a tutorial here to benefit all of our visitors. Free advice!

Feature teacher


Be inspired by some of our favorite teachers using our products.

Get professional support


Contact us now to request your own tutorial or learning resource.

This section doesn’t currently include any content. Add content to this section using the sidebar.

Image caption appears here

Add your deal, information or promotional text

ADA5159

Adafruit TCA4307 Hot-Swap I2C Buffer with Stuck Bus Recovery

7 items left

As we've been adding  STEMMA QT connectors to our breakouts and dev boards, folks have been really enjoying the simplicity and speed of plugging in I2C sensors and devices for quick iteration and design. That's all good, but I2C wasn't really designed for hot-plugging. You're kinda supposed to have everything connected once on boot and never mess with it - I2C was specified for on-board connections. And, folks who have experimented with hot-plugging I2C devices eventually have discovered that if you plug in or unplug at the wrong moment you can cause the bus to hang due to an extra SCL pulse or an unexpected capacitive load.

The Adafruit TCA4307 Hot-Swap I2C Buffer breakout here solves that problem. It's specifically designed to take a non-hot-swap protocol (I2C) and protect the controller from wayward peripherals messing with the bus during attach/detach.

Usage is super simple. Connect the left side (IN) to your main board controller - Arduino, Raspberry Pi, Feather, etc. Then connect any I2C sensors you like to OUT side. Power is connected through - this isn't a power isolator, just a bus buffer. You can use 2.3 to 5.5V DC power and logic levels.

The chip can handle up to 400KHz I2C clock rates and even has stuck bus recovery: it automatically disconnects the bus if it detects either SDAOUT or SCLOUT are low for about 40 ms. Once the bus is disconnected, the device automatically generates up to 16 pulses on SCLOUT to attempt to reset the device which is holding the bus low.

There's also an extra ENable pin, if you want to disconnect the in and out sides, and a READY pin that will let you know if the peripheral is buffer-connected to the controller (and is safe to attempt communication with)

To get you going fast, we spun up a custom-made PCB in the STEMMA QT form factor, making it easy to interface with. The STEMMA QT connectors on either side are compatible with the SparkFun Qwiic I2C connectors. This allows you to make solderless connections between your development board and the TCA4307 or to chain it with a wide range of other sensors and accessories using a compatible cableQT Cable is not included, but we have a variety in the shop

https://www.youtube.com/embed/tWRryzapiTc?start=412

https://www.youtube.com/embed/6GXRRuFuFy0

How We Give Back

We believe in giving back; We are proud to give 1% of all orders directly to environmental not for profit groups whose focus is the protection, preservation and restoration of our planet. This means every time you purchase from us, 1% goes directly to an environmental cause.

Search