Bit:2:Pi BBC Micro:Bit adaptor for Raspberry Pi HATs

by 4Tronixs
Save 50%
$29.99
$14.99
Bit:2:Pi Allows the BBC Micro:Bit to Connect to Raspberry Pi Addon Boards

NB. BBC Micro:Bit and Unicorn pHat are NOT included

The Bit:2:Pi enables you to re-use all those hundreds of Raspberry Pi addon boards and HATs.

Simply plug your Micro:Bit into the edge connector and the required Raspberry Pi Hat onto the GPIO connector, then program your Micro:Bit to control the new board. Most Raspberry Pi boards are very simple to program as they are controlled by simple on/off signals on the GPIO connector which are easily copied in the Micro:Bit. We have also used Neopixel hats (eg. Unicorn from Pimoroni) with great success and are happily communicating via I2C as well.

Selecting which Micro:Bit pin is connected to which GPIO pin, is via a set of configurable jumpers. There is a default set of connections that work for the most common boards, including I2C and SPI connections, but it is a simple matter to unplug a jumper or two and replace it with a longer wire jumper (4 included) to connect your preferred pins.

Current boards tested are:
4tronix: PlayHat, Picon Zero, PiStop, motor controllers
Pimoroni: Pibrella, Unicorn pHat/HAT. Explorer, Enviro pHat, Blinkt, Scroll pHat

This board is supplied in two versions, both fully soldered:
1. Without battery holder
2. Including 3xAA battery holder so you can run your Raspberry Pi add-ons without wires!

Power is supplied to the board and the micro:bit via the micro-USB connector on the side, but there is also an option to add a battery holder to allow completely wire-free operation.